Free STL file MMCX Connector Mod for Koss Porta Pro headphones 🎧・Design to download and 3D print・Cults

(New version, which uses a nut to retain the MMCX connector, has been added) Removeable cables makes everything classier, especially the now ubiquitous Koss Porta Pros. This model is a holder for an MMCX connector. The connector can be found on and should be the shorter (8.5mm overall length) M3 threaded version. The holder will need the mounting hole drilled and tapped out to M3. The two screws used are M2x6mm button heads. They screw straight into the pre-existing holes on the driver back and don't require the holes to be drilled or tapped. The inner pin should be wired to the driver where the red or green signal wire was soldered and the outer tap should connect to the gold ground wires position. The cable I used is a generic MMCX one for the Shure SE425s as well as many others, from . I had to cut off the stiff shaped sheathing on the wires at the MMCX connector ends.

Modded my KSC75 [mmcx mod with 3D printed adapter] : r/headphones

Modded my KSC75 [mmcx mod with 3D printed adapter] : r/headphones

▷ koss portapro mods 3d models 【 STLFinder 】

Ultimate Guide] Koss Modification – Ear Pads, MMCX Sockets, and Detachable Cables, Oh My!

Voarmaks DIY Modification MMCX Sockets Cover Parts Compatible with Koss Porta Pro Portapro Headphone Ear Pads Foam Cushion : Electronics

▷ koss portapro repair 3d models 【 STLFinder 】

Free STL file MMCX Connector Mod for Koss Porta Pro headphones 🎧・Design to download and 3D print・Cults

Ultimate Guide] Koss Modification – Ear Pads, MMCX Sockets, and Detachable Cables, Oh My!

koss 3D Models to Print - yeggi

quest 3 koss 3D Models to Print - yeggi - page 18

▷ ksc75 mods 3d models 【 STLFinder 】

In addition, I also provide finished products after modification. Mmcx modification can permanently solve the problem of headphone cable aging.

MMCX Modded Speaker Driver Unit For Koss Porta Pro Portapro PP Headphone Ear Pad

koss ksc75 mmcx adapter by 3D Models to Print - yeggi